From: Plank, Jason (JPlank@concordefs.com)
Date: Thu Jun 08 2006 - 08:49:06 ART
Try using the "show traffic-shape queue" command once your map-class is
assigned.
-------------------
J. Marshall Plank
Network Engineer
101 Bellevue Parkway
Wilmington, DE 19809
E-mail: JPlank@concordefs.com
Phone: 302-793-5913
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On Behalf Of Sami
Sent: Thursday, June 08, 2006 4:48 AM
To: Cisco certification
Subject: FRTS
Group,
When FRTS is enabled on interface and at the same time I want to enable WFQ
on that interface for VoIP traffice ( RSVP), it's strange instead of WFQ
, router enable priority queuing on FR interface.
Is this normal behaviour in FR ??
R3#show queueing interface s0/0/0
Interface Serial0/0/0 queueing strategy: none
R3#conf t
R3(config)#map-class frame-relay R3
R3(config-map-class)#fra
R3(config-map-class)#frame-relay fair-queue
R3(config)#interface s0/0/0
R3(config-if)#frame-relay class R3
R3#show queueing interface s0/0/0
Interface Serial0/0/0 queueing strategy: priority
Output queue utilization (queue/count)
high/0 medium/0 normal/9 low/0
R3# interface Serial0/0/0
no ip address
encapsulation frame-relay IETF
no fair-queue
frame-relay class R3
frame-relay traffic-shaping
frame-relay lmi-type cisco
R3(config)#int s0/0/0
R3(config-if)#fa
R3(config-if)#fair-queue
Cannot change interface queuing when Frame-Relay traffic-shapi
ng is configured
R3(config-if)#
It means when FRTS is enabled , I can not user RSVP for VOIP application ...
am i correct ??
Thanks
This archive was generated by hypermail 2.1.4 : Sat Jul 01 2006 - 07:57:32 ART