FRTS

From: Sami (sy1977@gmail.com)
Date: Thu Jun 08 2006 - 05:47:54 ART

• Next message: Darby Weaver: "Re: ip multicast rate-limit [KZ]"
• Previous message: Koen Zeilstra: "Re: ip multicast rate-limit [KZ]"
• Next in thread: Plank, Jason: "RE: FRTS"
• Maybe reply: Plank, Jason: "RE: FRTS"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

Group,

When FRTS is enabled on interface and at the same time I want to enable WFQ
on that interface for VoIP traffice ( RSVP), it's strange instead of WFQ
, router enable priority queuing on FR interface.

Is this normal behaviour in FR ??

R3#show queueing interface s0/0/0
Interface Serial0/0/0 queueing strategy: none

R3#conf t
R3(config)#map-class frame-relay R3
R3(config-map-class)#fra
R3(config-map-class)#frame-relay fair-queue

R3(config)#interface s0/0/0
R3(config-if)#frame-relay class R3

R3#show queueing interface s0/0/0
Interface Serial0/0/0 queueing strategy: priority

Output queue utilization (queue/count)
        high/0 medium/0 normal/9 low/0

R3# interface Serial0/0/0
 no ip address
 encapsulation frame-relay IETF
 no fair-queue
 frame-relay class R3
 frame-relay traffic-shaping
 frame-relay lmi-type cisco

R3(config)#int s0/0/0
R3(config-if)#fa
R3(config-if)#fair-queue
Cannot change interface queuing when Frame-Relay traffic-shapi
ng is configured
R3(config-if)#

It means when FRTS is enabled , I can not user RSVP for VOIP application ...
am i correct ??

Thanks

• Next message: Darby Weaver: "Re: ip multicast rate-limit [KZ]"
• Previous message: Koen Zeilstra: "Re: ip multicast rate-limit [KZ]"
• Next in thread: Plank, Jason: "RE: FRTS"
• Maybe reply: Plank, Jason: "RE: FRTS"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

This archive was generated by hypermail 2.1.4 : Sat Jul 01 2006 - 07:57:32 ART