ipv6 tunnel problem

From: Shafeen Ibrahim (shafeen.i@gmail.com)
Date: Sun Jun 04 2006 - 19:28:04 ART

• Next message: PhiL: "Re: Most efficient ACL to match multiple networks - easier way?"
• Previous message: Larry Chuon: "Re: Most efficient ACL to match multiple networks - easier way?"
• Next in thread: johngibson1541@yahoo.com: "Re: ipv6 tunnel problem"
• Maybe reply: johngibson1541@yahoo.com: "Re: ipv6 tunnel problem"
• Maybe reply: Jian Gu: "Re: ipv6 tunnel problem"
• Maybe reply: Godswill Oletu: "Re: ipv6 tunnel problem"
• Maybe reply: Godswill Oletu: "Re: ipv6 tunnel problem"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

hi,

     I have a problem with IEWB LAB 11 , the section(7.2) related to setting
up ipv6 tunnels . The requirement is to setup an ipv6 fully meshed tunnel
between routers R1,R4 and R6.

I enabled ipv6 ISATAP tunnel mode on the interface and enabled ipv6 rip on
the tunnel . The
ipv6 routing table doesn't show any rip routes , but i am able to ping
the all other routers tunnel interface ipv6 address.

I would like to know if any static routes need to be created for the rip
routes to be propagated .

Thanks

• Next message: PhiL: "Re: Most efficient ACL to match multiple networks - easier way?"
• Previous message: Larry Chuon: "Re: Most efficient ACL to match multiple networks - easier way?"
• Next in thread: johngibson1541@yahoo.com: "Re: ipv6 tunnel problem"
• Maybe reply: johngibson1541@yahoo.com: "Re: ipv6 tunnel problem"
• Maybe reply: Jian Gu: "Re: ipv6 tunnel problem"
• Maybe reply: Godswill Oletu: "Re: ipv6 tunnel problem"
• Maybe reply: Godswill Oletu: "Re: ipv6 tunnel problem"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

This archive was generated by hypermail 2.1.4 : Sat Jul 01 2006 - 07:57:32 ART