From: Schulz, Dave (DSchulz@dpsciences.com)
Date: Wed May 17 2006 - 01:04:27 ART
I was configuring GLBP in the lab and ran into an issue with a
configuration between two routers, R2 and R4. R2 is the meant to be the
active router. However, using object tracking....I would like R4 to
become the active router. This easily works with HSRP and VRRP, but
GLBP has me stumped, even after going through all the docCD information
on this. Thoughts?
R2.....
!
track 1 interface Serial0/0 line-protocol
!
interface FastEthernet0/0
ip address 40.4.4.2 255.255.255.0
duplex auto
speed auto
glbp 1 ip 40.4.4.10
glbp 1 priority 105
glbp 1 preempt
glbp 1 weighting 110 lower 90
glbp 1 authentication text cisco
glbp 1 weighting track 1 decrement 20
!
interface Serial0/0
ip address 192.168.1.2 255.255.255.0
encapsulation frame-relay
R4......
!
!
interface FastEthernet0/0
ip address 40.4.4.4 255.255.255.0
duplex half
speed 10
glbp 1 ip 40.4.4.10
glbp 1 preempt
glbp 1 authentication text cisco
R2 (show glbp).....
R2#sh glb
FastEthernet0/0 - Group 1
State is Active
7 state changes, last state change 00:08:03
Virtual IP address is 40.4.4.10
Hello time 3 sec, hold time 10 sec
Next hello sent in 2.544 secs
Redirect time 600 sec, forwarder time-out 14400 sec
Preemption enabled, min delay 0 sec
Active is local
Standby is 40.4.4.4, priority 100 (expires in 7.416 sec)
Priority 105 (configured)
Weighting 90 (configured 110), thresholds: lower 90, upper 110
Track object 1 state Down decrement 20
Load balancing: round-robin
There are 2 forwarders (1 active)
Forwarder 1
State is Listen
6 state changes, last state change 00:07:48
MAC address is 0007.b400.0101 (learnt)
Owner ID is 0002.1751.4000
Redirection enabled, 597.412 sec remaining (maximum 600 sec)
Time to live: 14397.412 sec (maximum 14400 sec)
Preemption enabled, min delay 30 sec
Active is 40.4.4.4 (primary), weighting 100 (expires in 9.204 sec)
Forwarder 2
State is Active
5 state changes, last state change 00:08:14
MAC address is 0007.b400.0102 (default)
Owner ID is 0008.a3fb.ddc1
Redirection enabled
Preemption enabled, min delay 30 sec
Active is local, weighting 90
Dave Schulz,
Email: dschulz@dpsciences.com <mailto:dschulz@dpsciences.com >
This archive was generated by hypermail 2.1.4 : Thu Jun 01 2006 - 06:33:21 ART