From: CCIEin2006 (ciscocciein2006@gmail.com)
Date: Sun May 14 2006 - 17:04:08 ART
Thanks Petr - I did have "no ip routing" configured but I didn't know the
rule that you could only have one active IP interface for the arp requests
to be sent.
I had two active IP interfaces. Once I shut down the other active IP
interface it started sending the ARP requests and had full connectivity!
On 5/14/06, Petr Lapukhov <petrsoft@gmail.com> wrote:
>
> Hello,
>
> You can turn router into a "dumb" host simply issuing "no ip routing"
> command.
> It will then send ARP requests for _any_ destination. Just make sure you
> have
> only one active IP interface :)
>
> HTH
> Petr
>
> 2006/5/14, CCIEin2006 <ciscocciein2006@gmail.com>:
> >
> > Hello group,
>
> I know proxy-arp (which is enable by default) can be used to provide hosts
> reachability without them having to be configured with a default-gateway.
>
> Does anyone know if this can be used to provide other routers with
> reachability without having to specify a default gateway or run any
> routing
> protocol?
>
> _______________________________________________________________________
> Subscription information may be found at:
> http://www.groupstudy.com/list/CCIELab.html
This archive was generated by hypermail 2.1.4 : Thu Jun 01 2006 - 06:33:21 ART