IEWBv3 Lab16 Task9.1 - verify source/unicast

From: allboutcisco (frenzeus@streamyx.com)
Date: Fri May 12 2006 - 03:48:01 ART

• Next message: Skinner, Stephen: "RE: using USB card reader/writer to upgrade I.O.S."
• Previous message: george stanza: "Re: question on BGP:: neighbor local-as !!"
• Next in thread: CCIEin2006: "Re: IEWBv3 Lab16 Task9.1 - verify source/unicast"
• Maybe reply: CCIEin2006: "Re: IEWBv3 Lab16 Task9.1 - verify source/unicast"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

Hi group,

Looking at the command "ip verify unicast reverse-path" being enabled on an interface to do an rpf check on source addresses of ip packets received, wouldn't this command have effect only if IP processing is enabled on that particular interface?

The reason being is in Solution Guide for IEWBv3 Lab16 Task9.1, this command is enabled on R2's int fa0/0 instead of BVI1. Maybe someone could point me to my mistake in understanding that IP processing is not enabled on R2's int fa0/0 since a "show ip int fa0/0" to verify the command "ip verify unicast reverse-path" states "Internet protocol processing disabled".

Thanks everyone in advance.

-K

• Next message: Skinner, Stephen: "RE: using USB card reader/writer to upgrade I.O.S."
• Previous message: george stanza: "Re: question on BGP:: neighbor local-as !!"
• Next in thread: CCIEin2006: "Re: IEWBv3 Lab16 Task9.1 - verify source/unicast"
• Maybe reply: CCIEin2006: "Re: IEWBv3 Lab16 Task9.1 - verify source/unicast"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

This archive was generated by hypermail 2.1.4 : Thu Jun 01 2006 - 06:33:21 ART