From: Vincent Mashburn (vmashburn@fedex.com)
Date: Wed May 10 2006 - 10:21:30 ART
You could also use some sort of tagging to differentiate international
packets from national traffic. You could tag the traffic at the source
via IP Precedence/DSCP (or you could use a route-map and create an
arbitrary tag that way). Then, at the destination, you could set up
some sort of route-map or MQC class-map to match on that tag. I am not
sure how versatile this would be when issuing show commands, but it may
be worth labbing it up to see if it will give you what you want.
Vince Mashburn
Voice / Data Engineer
901-263-5072
CCVP, CCNP, CCDA,Network +
Cisco IP Telephony Support Specialist
Cisco IP Telephony Operations Specialist
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On Behalf Of
Nawaz, Ajaz
Sent: Wednesday, May 10, 2006 4:33 AM
To: 'Ellis Chan'; ccielab@groupstudy.com
Subject: RE: Identify national and international IP traffic on router.
Ip accounting feature may be of some use.
Hth
Ajaz
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On Behalf Of
Ellis Chan
Sent: 10 May 2006 08:58
To: ccielab@groupstudy.com
Subject: Identify national and international IP traffic on router.
Hello team,
We have a direct fibre connected to
data centre,
Is it possible to configure Cisco router to
determine IP traffic volume for national and
international traffic?
Thanks for your help
This archive was generated by hypermail 2.1.4 : Thu Jun 01 2006 - 06:33:21 ART