From: Brian McGahan (bmcgahan@internetworkexpert.com)
Date: Thu May 04 2006 - 14:36:38 ART
Unless there is a specific requirement in the lab to use the
minimum amount of lines to accomplish something it doesn't matter. The
end result of the configuration is many times more important than the
actual steps you use to get there.
HTH,
Brian McGahan, CCIE #8593
bmcgahan@internetworkexpert.com
Internetwork Expert, Inc.
http://www.InternetworkExpert.com
Toll Free: 877-224-8987 x 705
Outside US: 775-826-4344 x 705
24/7 Support: http://forum.internetworkexpert.com
Live Chat: http://www.internetworkexpert.com/chat/
> -----Original Message-----
> From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On Behalf
Of
> Ken
> Sent: Wednesday, May 03, 2006 7:50 PM
> To: Cisco certification
> Subject: IEWB Lab4 Task 4.8 passive-interface command
>
> Hello,
>
> This is a question regarding the configuration on R3.
>
> The solution guide shows that passive-interface default command
> is configured.
>
> However isn't it easier to just configure passive-interface command
> on s1/0 interface like below?
>
>
> router rip
> version 2
> network 141.1.0.0
> passive-interface serial 1/0
> no auto-summary
>
> I need fewer lines of commands this way. Or would I lose point
> if I do this?
>
>
> -Ken,
>
>
This archive was generated by hypermail 2.1.4 : Thu Jun 01 2006 - 06:33:20 ART