From: Alexei Monastyrnyi (alexeim@orcsoftware.com)
Date: Fri Apr 28 2006 - 09:55:56 GMT-3
My understanding is it is relevant if you use "bandwidth percent" in
your MQC configuration or something similar referring to relative
bandwidth, being opposed to absolute values... But I might miss
something here.
I.e. if you need to configure bandwidth 512K in your MQC task, no
technical need for "bandwith" on interface. Though in real life you'd
better keep it in sync with real bandwidth just to be as consistent as
possible with your OSPF or EIGHR domains etc
A.
on 28/04/2006 12:19 Shamin wrote:
> Hi,
>
> First of all my thanks to all you guys for your great inputs.
>
> This is with reference to the IEWB LAB2 Ver3.0 Task 8.2
>
> It is mentioned in the solution guide as follows ..
>
> "Output queue calculations for the MQC are based on the configured
> bandwidth value of the interface and not the speed the interface is
> clocked at.Be sure to set the appropriate bandwidth value when
> configuring the MQC on an interface"
>
> As per this statement , what I understand is, when configuring MQC on
> any interface, it is necessary that we configure the bandwidth command
> on the main interface, even if it is not mentioned in the lab
> requirements.
>
> What confused me was that, for a similar task in LAB4 Ver3.0 Task 8.2,
> there was no bandwidth configured under the main interface.
>
> So i am bit confused here, My question will be, is it mandatory to
> configure the banwidth command on the main interface for MQC, even if
> it is not mentioned in the LAB requirements?
>
> Regards
> shamin
>
> _______________________________________________________________________
> Subscription information may be found at:
> http://www.groupstudy.com/list/CCIELab.html
This archive was generated by hypermail 2.1.4 : Mon May 01 2006 - 11:41:59 GMT-3