From: Victor Cappuccio (cvictor@protokolgroup.com)
Date: Wed Mar 22 2006 - 22:26:19 GMT-3
Hello List, is there any way to know which is the next hop for ip mroute
in a multi-access media??
I have a multicast topology like this
228.22.22.22 |==E0= R2 -S0---------S0-R5 -S1 ----S0-- R1 =E0 ==== E0 =
R3-- |
All the interfaces are running ip pim sparse-dense-mode, and the problem
is that the RPF Fails, because there is a ppp link between R2 and R3 and
the unicast routing prefers that link to reach destinations in R3/R2, so
where do you put the ip mroute 0.0.0.0 255.255.255.255 (on R2 or R3?)
and which is the next hop required?
Rack1R3#show ip pim interface
Address Interface Ver/ Nbr Query DR DR
Mode Count Intvl Prior
136.1.3.3 Ethernet0/0 v2/SD 0 30 1
136.1.3.3
136.1.136.3 Ethernet0/1 v2/D 1 30 1
136.1.136.3
====
Rack1R1#ping 228.22.22.22 source 136.1.136.1 (this is the network
where R3 also is)
Type escape sequence to abort.
Sending 1, 100-byte ICMP Echos to 228.22.22.22, timeout is 2 seconds:
Packet sent with a source address of 136.1.136.1
.
Rack1R1#
Rack1R1#ping 228.22.22.22
Type escape sequence to abort.
Sending 1, 100-byte ICMP Echos to 228.22.22.22, timeout is 2 seconds:
Reply to request 0 from 136.1.245.2, 176 ms
Rack1R1#
====
Rack1R1#show ip pim neighbor
PIM Neighbor Table
Neighbor Interface Uptime/Expires Ver DR
Address Prio/Mode
136.1.136.3 FastEthernet0/0 01:22:25/00:01:29 v2 1 / DR S
136.1.15.5 Serial0/0 03:31:31/00:01:25 v2 1 / DR S
Thanks
Victor.
This archive was generated by hypermail 2.1.4 : Sat Apr 01 2006 - 10:07:39 GMT-3