From: Dennis Worth (Dennis.Worth@oomc.com)
Date: Thu Mar 02 2006 - 13:47:53 GMT-3
Hey Group,
Has any one setup a dial-in remote management with on of
these WIC-1AM cards?
Async0/3/0 is up (spoofing), line protocol is up (spoofing)
Hardware is GT96K SmartSCM Integrated Modem
Interface is unnumbered. Using address of Loopback0 (10.64.0.20)
MTU 1500 bytes, BW 56 Kbit, DLY 100000 usec,
reliability 255/255, txload 1/255, rxload 1/255
Encapsulation SLIP, loopback not set
DTR is pulsed for 5 seconds on reset
Last input never, output never, output hang never
Last clearing of "show interface" counters never
Input queue: 0/75/0/0 (size/max/drops/flushes); Total output drops: 0
Queueing strategy: weighted fair
Output queue: 0/1000/64/0 (size/max total/threshold/drops)
Conversations 0/0/16 (active/max active/max total)
Reserved Conversations 0/0 (allocated/max allocated)
Available Bandwidth 42 kilobits/sec
5 minute input rate 0 bits/sec, 0 packets/sec
5 minute output rate 0 bits/sec, 0 packets/sec
0 packets input, 0 bytes, 0 no buffer
Received 0 broadcasts, 0 runts, 0 giants, 0 throttles
0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored, 0 abort
0 packets output, 0 bytes, 0 underruns
0 output errors, 0 collisions, 0 interface resets
0 output buffer failures, 0 output buffers swapped out
0 carrier transitions
DCD=down DSR=up DTR=up RTS=up CTS=up
line 0/3/0
modem InOut
modem autoconfigure discovery
transport input all
transport output all
stopbits 1
speed 115200
Dennis Worth
Network Engineer
Option One Mortgage
phone. 949-790-3687
dennis.worth@oomc.com <mailto:dennis.worth@oomc.com>
This archive was generated by hypermail 2.1.4 : Sat Apr 01 2006 - 10:07:37 GMT-3