Re: Frame relay DE-bit

From: Chris Atkins (chris_atkins@blueyonder.co.uk)
Date: Fri Jan 13 2006 - 19:11:07 GMT-3

• Next message: Chris Atkins: "Fw: PIM Dense-Mode"
• Previous message: Masood Quadri: "Re: R&S and SAN (iementor?!!)"
• Maybe in reply to: Chris Atkins: "Frame relay DE-bit"
• Next in thread: Chris Lewis: "Re: Frame relay DE-bit"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

Hi all
Still bit lost on this, if i could put a sniffer on would. Any sugestions most
appreciated.

Cheers

Chris
  ----- Original Message -----
  From: Chris Atkins
  To: ccielab@groupstudy.com
  Sent: Friday, January 13, 2006 2:37 PM
  Subject: Frame relay DE-bit

  Hi all
  Quick question, would the config below ensure that PIM is not marked with
the DE bit set, or should I just have the permit IP any any statement so only
IP traffic is marked ? bit confused :o)

  frame-relay de-list 10 protocol ip list 100
  !
  access-list 102 deny pim any any
  access-list 102 permit ip any any
  !
  interface Serial0/0
   ip address 172.16.23.2 255.255.255.248
   encapsulation frame-relay
   ip ospf network point-to-point
   ip ospf priority 0
   frame-relay de-group 10 403
   frame-relay map ip 172.16.23.1 403 broadcast
   no frame-relay inverse-arp

  Thanks in advance.

  Chris

• Next message: Chris Atkins: "Fw: PIM Dense-Mode"
• Previous message: Masood Quadri: "Re: R&S and SAN (iementor?!!)"
• Maybe in reply to: Chris Atkins: "Frame relay DE-bit"
• Next in thread: Chris Lewis: "Re: Frame relay DE-bit"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

This archive was generated by hypermail 2.1.4 : Wed Feb 01 2006 - 07:45:49 GMT-3