From: Tim (ccie2be@nyc.rr.com)
Date: Fri Jan 06 2006 - 13:14:19 GMT-3
In real world, that's typically built-in to the application. For example,
ripv2, ospf and eigrp all use mcast to send out packets and that all happens
without you doing a thing - it's just how those routing protocols are
designed.
In a lab or test situation, you can just use the router to ping to simulate
a mcast stream, for example, ping 225.25.25.25 repeat 10000.
HTH, Tim
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On Behalf Of
Mohammed Shameen Abdul Jabbar
Sent: Friday, January 06, 2006 10:44 AM
To: Cisco certification
Subject: What can be a multicast source?
Hi,
I am studying multicast concepts now and working out the scenarios in Jeff
Doyle Vol 2.
After i did configure all the routers,to test the configurations there need
to be multicast source.
Can anyone tell how will a Multicast source be set up!!
Sorry if my question is too basic for this group.
I have anothe question too..
Does the clock rate configured on a DCE end has any effect on the interface
bandwidth.
FOr example the max available banwidth considerations that is done in QOS.
Thankyou for the reply
regards
shamin
This archive was generated by hypermail 2.1.4 : Wed Feb 01 2006 - 07:45:47 GMT-3