From: Nadeem Zahid \(iszahid\) (iszahid@cisco.com)
Date: Mon Jan 02 2006 - 21:26:32 GMT-3
I don't think that applies to this <as it also has .s instead of :s>
unlike all-v6 address in hex unless I'm wrong.
Check page 651 of Doyle Vol-2 for format X:X:X:X:X:X::d.d.d.d
/Nadeem
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On Behalf Of
joshua lauer
Sent: Monday, January 02, 2006 4:18 PM
To: Nadeem Zahid (iszahid); ccielab@groupstudy.com
Subject: Re: IPv6/IPv4 address
check the IPV6 configuration guide on CCO. there is detailed example on
how to convert and IPV4 address to V6. Your example here is incorrect.
Remember the V6 address is hex.
JL
----- Original Message -----
From: "Nadeem Zahid (iszahid)" <iszahid@cisco.com>
To: <ccielab@groupstudy.com>
Sent: Monday, January 02, 2006 7:00 PM
Subject: IPv6/IPv4 address
> I'm unable to determine how to configure IPv6 address on an interface
> such that its IPv4 address is used
> as IPv6 address. Example: if v4 address is 10.1.1.1/24 I try to
> configure v6 address as ::10.10.1.1 but it is
> rejected. Any references/config examples?
> regs
>
>
This archive was generated by hypermail 2.1.4 : Wed Feb 01 2006 - 07:45:47 GMT-3