From: Schulz, Dave (DSchulz@dpsciences.com)
Date: Thu Nov 17 2005 - 15:47:33 GMT-3
Bill -
You'll need to enable cdp on the frame interfaces, since it is disabled
by default whenever you enable frame-relay encapsulation.
Dave Schulz,
Email: dschulz@dpsciences.com
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On Behalf Of
Bill.McKenzie@bisys.com
Sent: Thursday, November 17, 2005 11:08 AM
To: ccielab@groupstudy.com
Subject: ODR problem
I'm having an ODR problem. (and that doesn't mean I'm having an odor
problem :)
ODR is supposed to run between the Hub (R3) and the Spoke (Frame Router)
over the Ethernet link.
I did the l2protocol-tunneling cdp on the switch ports to which each
router's Ethernet connects.
I enabled router odr on R3 with net 172.16.0.0 under the process.
I turned off ip routing on the Frame Router.
Here's what's happening:
I get the loopback interface on R3's routing table via ODR.
The Frame Router gets no default route or any route at all.
I have 12.3 on R3 and 12.1 (5T12) on the Frame Router.
By the way , this is DoiT II lab 2 from Netmaster .
Any ideas?
Thanks,
Bill
============================================
STATEMENT OF CONFIDENTIALITY
The information contained in this electronic message and any attachments
to
this message are intended for the exclusive use of the addressee(s) and
may
contain confidential or privileged information. No representation is
made
on its accuracy or completeness of the information contained in this
electronic message. Certain assumptions may have been made in the
preparation of this material as at this date, and are subject to change
without notice. If you are not the intended recipient, you are hereby
notified that any dissemination, distribution or copying of this e-mail
and
any attachment(s) is strictly prohibited.
Please reply to the sender and destroy all copies of this message and
any
attachments from your system.
This archive was generated by hypermail 2.1.4 : Thu Dec 01 2005 - 09:12:07 GMT-3