From: Schulz, Dave (DSchulz@dpsciences.com)
Date: Fri Nov 11 2005 - 16:11:31 GMT-3
Montiean -
The dialer group is needed to define the interesting traffic. This is
needed to know which traffic will keep the line up (for the
idle-timeout).
Dave Schulz,
Email: dschulz@dpsciences.com
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On Behalf Of
Montiean
Sent: Friday, November 11, 2005 12:50 PM
To: ccielab@groupstudy.com
Subject: dialer-group under BRI interface
Folks,
Let say the question asking only one side to initiate the call so on
other site will just configure "dialer map" without remote isdn calling
number. This would be enough not to let the router call out.
However, in some solution guide from lab workbook use additional
command
like " dialer-group" on the side that doesnot need to initiate the call.
As
I know, dialer-group will use to screen the traffic to initiate the
call. I
am not sure why we still need it as above scenario.
Any ideas?
Thanks,
Montiean
This archive was generated by hypermail 2.1.4 : Thu Dec 01 2005 - 09:12:06 GMT-3