From: Montiean (noktes@bellsouth.net)
Date: Fri Nov 11 2005 - 14:49:47 GMT-3
Folks,
Let say the question asking only one side to initiate the call so on
other site will just configure "dialer map" without remote isdn calling
number. This would be enough not to let the router call out.
However, in some solution guide from lab workbook use additional command
like " dialer-group" on the side that doesnot need to initiate the call. As
I know, dialer-group will use to screen the traffic to initiate the call. I
am not sure why we still need it as above scenario.
Any ideas?
Thanks,
Montiean
This archive was generated by hypermail 2.1.4 : Thu Dec 01 2005 - 09:12:06 GMT-3