From: Ralph (Mandela@myrealbox.com)
Date: Fri Oct 28 2005 - 19:21:39 GMT-3
Leigh,
On R1 interface to R2 Configure ip summary-address eigrp 1 20.20.0.0 255.255.0.0
And use distribute-list (RIP) on R2 to filter the /24s from getting to R3
HTH
Ralph.
-----Original Message-----
From: Leigh Harrison <ccileigh@gmail.com>
To: FORUM <ccielab@groupstudy.com>
Date: Fri, 28 Oct 2005 21:38:10 +0100
Subject: RIP Route
Hey there,
I've got a requirement to only send 20.20.0.0/16 through to a router in
rip:-
R1 -- eigrp -- R2 -- rip -- R3
R1 has the addresses 20.20.1.1 and 20.20.12.1
R2 has the addresses 20.20.2.2 , 20.20.12.2 and 50.50.23.2
R3 has got 50.50.23.3 and some routes in the 200.x.x.x range
I've redistributed through, but there is a requirement to send only
20.20.0.0/16 to R3.
Not allowed to use ip summary address.
I can't figure it without using a static route.
Any ideas ?
LH
This archive was generated by hypermail 2.1.4 : Sun Nov 06 2005 - 22:00:55 GMT-3