RIP Route

From: Leigh Harrison (ccileigh@gmail.com)
Date: Fri Oct 28 2005 - 17:38:10 GMT-3

• Next message: Ryan, Jeff: "Cisco - TIS - Config + Pricing Tool"
• Previous message: Mike King: "CallManager and NTP problems"
• Next in thread: Ralph: "Re: RIP Route"
• Maybe reply: Ralph: "Re: RIP Route"
• Maybe reply: Vincent Mashburn: "RE: RIP Route"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

Hey there,

I've got a requirement to only send 20.20.0.0/16 through to a router in
rip:-

R1 -- eigrp -- R2 -- rip -- R3

R1 has the addresses 20.20.1.1 and 20.20.12.1
R2 has the addresses 20.20.2.2 , 20.20.12.2 and 50.50.23.2
R3 has got 50.50.23.3 and some routes in the 200.x.x.x range

I've redistributed through, but there is a requirement to send only
20.20.0.0/16 to R3.
Not allowed to use ip summary address.

I can't figure it without using a static route.

Any ideas ?

LH

• Next message: Ryan, Jeff: "Cisco - TIS - Config + Pricing Tool"
• Previous message: Mike King: "CallManager and NTP problems"
• Next in thread: Ralph: "Re: RIP Route"
• Maybe reply: Ralph: "Re: RIP Route"
• Maybe reply: Vincent Mashburn: "RE: RIP Route"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

This archive was generated by hypermail 2.1.4 : Sun Nov 06 2005 - 22:00:55 GMT-3