From: Cisco Nuts (cisconuts@hotmail.com)
Date: Thu Oct 27 2005 - 05:40:50 GMT-3
Hi: This might be a stupid question but when you configure the be value
under the policy-map, why do you not see it when you do a show policy-map
int ?? policy-map CAR
class ICMP
police cir 8000 bc 2000 be 2000
conform-action drop
exceed-action drop r5#sh policy-map int s0/0 | beg ICMP
Class-map: ICMP (match-all)
0 packets, 0 bytes
5 minute offered rate 0 bps, drop rate 0 bps
Match: protocol icmp
police:
cir 8000 bps, bc 2000 bytes
conformed 0 packets, 0 bytes; actions:
drop
exceeded 0 packets, 0 bytes; actions:
drop
conformed 0 bps, exceed 0 bps Thanks !!!
This archive was generated by hypermail 2.1.4 : Sun Nov 06 2005 - 22:00:54 GMT-3