From: kevin gannon (kevin@gannons.net)
Date: Sun Oct 23 2005 - 16:37:56 GMT-3
with VRRP you can get away with using only 2 addresses instead of
three as with HSRP. Assuming two routers in the pair that is.
Regards
Kevin
On 10/23/05, Chris Lewis <chrlewiscsco@yahoo.com> wrote:
> Hi,
>
> Just looking for opinions and input.
>
> Comparing HSRP and VRRP, I conclude:
>
> VRRP has preempt on by default, therefore does not need it configured like HSRP does.
> HSRP can use enhanced object tracking
> (to track more than just line protocol up/down as follows)
> track 100 interface serial1/0 ip routing
> interface Ethernet0/0
> standby 1 track 100 decrement 10
> I do not see a command option for VRRP to use track, even though the enhanced object tracking documentation suggets there is. So I conclude VRRP cannot track the status of one of its interfaces like HSRP can.
> To load balance between routers, HSRP and VRRP can have different groups to prefer different routers, but anything more sophisticated required GLBP
> Any comments or other differentiators?
>
> Chris
>
>
>
> ---------------------------------
> Yahoo! FareChase - Search multiple travel sites in one click.
>
> _______________________________________________________________________
> Subscription information may be found at:
> http://www.groupstudy.com/list/CCIELab.html
>
> --
> This message has been scanned for viruses and
> dangerous content by MailScanner, and is
> believed to be clean.
This archive was generated by hypermail 2.1.4 : Sun Nov 06 2005 - 22:00:52 GMT-3