From: Michael Brooks (michaeljbrooks@gmail.com)
Date: Sun Oct 23 2005 - 13:28:46 GMT-3
Does anyone know if is possible to run frame-relay over V.24 cables ? If so
how ? If not, why not ?
The interface is sending LMI but not receiving over the V.24 cable.
*R1#sho int s0/0
Serial0/0 is up, line protocol is down
Hardware is PowerQUICC Serial
MTU 1500 bytes, BW 1544 Kbit, DLY 20000 usec, rely 255/255, load 1/255
Encapsulation FRAME-RELAY, loopback not set, keepalive set (10 sec)
LMI enq sent 7, LMI stat recvd 0, LMI upd recvd 0, DTE LMI down
LMI enq recvd 0, LMI stat sent 0, LMI upd sent 0
LMI DLCI 1023 LMI type is CISCO frame relay DTE*
**
*FRAMERELAYSWITCH#sho int s0/3
Serial0/3 is up, line protocol is down
Hardware is GT96K Serial
Description: To R1
MTU 1500 bytes, BW 1544 Kbit, DLY 20000 usec,
reliability 255/255, txload 1/255, rxload 1/255
Encapsulation FRAME-RELAY, loopback not set
Keepalive set (10 sec)
LMI enq sent 0, LMI stat recvd 0, LMI upd recvd 0
LMI enq recvd 0, LMI stat sent 0, LMI upd sent 0, DCE LMI down
LMI DLCI 1023 LMI type is CISCO frame relay DCE*
**
Thanks,
Mike
This archive was generated by hypermail 2.1.4 : Sun Nov 06 2005 - 22:00:52 GMT-3