From: George Amen (george.amen@gmail.com)
Date: Wed Oct 19 2005 - 20:55:10 GMT-3
The config below (from doc cd) shows an interface atm 0 with
'multipoint' as a keyword... I checked it on my router which is
running (C7200-JK9S-M), Version 12.2 T8, and I dont see this keyword
following ATM main interface.
Although I do see it when I creat a sub-if.
What am i missing here.... ???
Configuring ATM E.164 Auto Conversion Example
http://www.cisco.com/univercd/cc/td/doc/product/software/ios122/122cgcr/fwan_c/wcfatm.htm#wp1084486
======================From CD=============================
interface atm 0 multipoint
ip address 120.45.20.81 255.255.255.0
pvc 0/5 qsaal
exit
!
atm nsap-address 45.000120045020081F00000000.112233445566.00
atm e164 auto-conversion
svc nsap 45.000120045020071F00000000.665544332211.00
protocol ip 120.45.20.71
exit
===================================================
On my router:
R6#conf t
Enter configuration commands, one per line. End with CNTL/Z.
R6(config)#int atm 1/0 ?
<cr>
R6(config)#exit
R6#conf t
Enter configuration commands, one per line. End with CNTL/Z.
R6(config)#int atm 1/0.303 ?
mpls Treat as an MPLS link
multipoint Treat as a multipoint link
point-to-point Treat as a point-to-point link
tag-switching Treat as a tag switching link (obsolete, use mpls)
<cr>
==================================================
any suggestions?
- GA
This archive was generated by hypermail 2.1.4 : Sun Nov 06 2005 - 22:00:51 GMT-3