From: George Amen (george.amen@gmail.com)
Date: Wed Oct 19 2005 - 20:44:17 GMT-3
It worked with 'aal5snap' under PVC,, I was under the wrong assumption
that by default the ecanpsulation is AAL5SNAP...
Thanks alot
-sh
On 10/19/05, Eugene Ward <eward15@juno.com> wrote:
> Try this...
>
> pvc 0/306
> encapsulation aal5snap
>
> Eugene
>
> --------------------------------------------------------------------
> Here's the config
> R6----BB1
>
> R6:
>
> username BB1 password 0 CISCO
> !
> interface ATM1/0.306 point-to-point
> pvc 0/306
> protocol ppp dialer
> dialer pool-member 1
> !
> interface Dialer1
> ip address 54.6.8.6 255.255.255.0
> encapsulation ppp
> dialer pool 1
> ppp authentication pap
> ppp pap sent-username ROUTER6 password 0 CISCO
> !
> Should I be able to ping .254 i.e. BB1 ?
> because I cant,,
>
> I did a debug on ppp auth, I dont seem to be getting anything from BB1.
>
> sh atm ilmi-status
>
> Interface : ATM1/0 Interface Type : Private UNI (User-side)
> ILMI VCC : (0, 0) ILMI Keepalive : Disabled
> ILMI State: UpAndNormal
> Peer IP Addr: 54.2.9.100 Peer IF Name: ATM0/1/1
> Peer MaxVPIbits: 8 Peer MaxVCIbits: 14
> Active Prefix(s) :
> 47.0000.0000.0000.0000.0000.000a
>
> R6#ping 54.6.8.254
>
> Type escape sequence to abort.
> Sending 5, 100-byte ICMP Echos to 54.6.8.254, timeout is 2 seconds:
> ..
>
> This is my 1st shot at ATM configs, any help would be appreciated.
>
> - GA
>
>
>
> ___________________________________________________________________
> Try Juno Platinum for Free! Then, only $9.95/month!
> Unlimited Internet Access with 250MB of Email Storage.
> Visit http://www.juno.com/value to sign up today!
>
> _______________________________________________________________________
> Subscription information may be found at:
> http://www.groupstudy.com/list/CCIELab.html
This archive was generated by hypermail 2.1.4 : Sun Nov 06 2005 - 22:00:51 GMT-3