From: kevin gannon (kevin@gannons.net)
Date: Mon Oct 17 2005 - 16:04:58 GMT-3
Look at inject maps might fit in with your setup
depenind on the VLSM setup.
Regards
Kevin
On 10/17/05, jnkmail4eva@yahoo.com <jnkmail4eva@yahoo.com> wrote:
> I am going over a practice lab but I am not sure of the solution.
> I have a directly connected interface on Router A.
> I am suppose to advertise this route to my peers.
> I know I could use redistribution or the Network command to advertise it to my peers.
> Is there any other way to advertise it ?
>
> For ex
> Router A
> e0 - 1.1.1.1/32
>
> router bgp 1
> neigbor 10.10.10.10 remote-as 10
> network 1.1.1.1 mask 255.255.255.255
> OR
> redistribute connected route-map allow-e0-only
>
>
> Are there any other ways to advertise e0 to its peers ?
>
> _______________________________________________________________________
> Subscription information may be found at:
> http://www.groupstudy.com/list/CCIELab.html
>
> --
> This message has been scanned for viruses and
> dangerous content by MailScanner, and is
> believed to be clean.
This archive was generated by hypermail 2.1.4 : Sun Nov 06 2005 - 22:00:51 GMT-3