From: simon hart (simon@harttel.com)
Date: Mon Oct 17 2005 - 16:03:11 GMT-3
Do you have an aggregate for Network 1.1.1.1 in your bgp routing table being
advertised by a peer, say something like
1.0.0.0/8
If so you could use BGP inject map, to place the more specific route into
the bgp process.
Simon
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com]On Behalf Of
jnkmail4eva@yahoo.com
Sent: 17 October 2005 19:48
To: ccielab@groupstudy.com
Subject: BGP question for all !!
I am going over a practice lab but I am not sure of the solution.
I have a directly connected interface on Router A.
I am suppose to advertise this route to my peers.
I know I could use redistribution or the Network command to advertise it to
my peers.
Is there any other way to advertise it ?
For ex
Router A
e0 - 1.1.1.1/32
router bgp 1
neigbor 10.10.10.10 remote-as 10
network 1.1.1.1 mask 255.255.255.255
OR
redistribute connected route-map allow-e0-only
Are there any other ways to advertise e0 to its peers ?
This archive was generated by hypermail 2.1.4 : Sun Nov 06 2005 - 22:00:51 GMT-3