Isis network point-to-point issue

From: Tony Schaffran (tschaffran@cconlinelabs.com)
Date: Fri Oct 14 2005 - 11:43:35 GMT-3

• Next message: McCallum, Robert: "FW: [c-nsp] IPExpert workbook"
• Previous message: Anthony Sequeira: "Re: Difference between bpduguard & bpdufilter"
• Next in thread: Chris Lewis: "Re: Isis network point-to-point issue"
• Maybe reply: Chris Lewis: "Re: Isis network point-to-point issue"
• Maybe reply: Edwards, Andrew M: "RE: Isis network point-to-point issue"
• Maybe reply: Tony Schaffran: "RE: Isis network point-to-point issue"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

Has anybody else come across this?

I am configuring ISIS between two router across a frame relay network.

I am configuring the physical serial interface of each router.

Now I want to issue the command isis network point-to-point.

On my 7500 router, this command will take.

On my 3600 or 2600 router, this command is not available.

They are all running the same version of IOS.

Any suggestions?

Is there something different about the 2600/3600 serial interfaces compared
to the 7500 serial interface with regards to isis?

Tony Schaffran
Network Analyst
CCIE #11071
CCNP, CCNA, CCDA,
NNCDS, NNCSS, CNE, MCSE
 
www.cconlinelabs.com
Your #1 choice for online Cisco rack rentals.

• Next message: McCallum, Robert: "FW: [c-nsp] IPExpert workbook"
• Previous message: Anthony Sequeira: "Re: Difference between bpduguard & bpdufilter"
• Next in thread: Chris Lewis: "Re: Isis network point-to-point issue"
• Maybe reply: Chris Lewis: "Re: Isis network point-to-point issue"
• Maybe reply: Edwards, Andrew M: "RE: Isis network point-to-point issue"
• Maybe reply: Tony Schaffran: "RE: Isis network point-to-point issue"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

This archive was generated by hypermail 2.1.4 : Sun Nov 06 2005 - 22:00:51 GMT-3