From: Javier Tomé (fjtm@tid.es)
Date: Thu Oct 13 2005 - 02:13:53 GMT-3
Sorry Victor, on a second thought I notice I said something stupid.
Coming to my mind are unless three ways to try to accomplish this:
* With PBR (configuring "ip local policy route-map" command) in such
a way that all traffic is redirected to R2.
* Configuring a default-gateway (if not prohibited) with ip routing
disabled.
* Configuring R1 router to learn the default gateway through IRDP...
Right now I have no way of testing this. Any comments...
Javi
Javier Tomi wrote:
> You may use NAT on R1 to hide all external addresses...
>
> Victor Cappuccio wrote:
>
>> Hello People, consider this Scenario
>>
>> 10.1.1.0/24 R1 --- Ethernet --- R2 |
>> Network Cloud Running OSPF | R3.
>> ---Vlan 50 ----
>>
>> You are not allowed to configure any routing protocol on R1, but one
>> of the requirements is that R1 should be able to ping any ip address
>> in R3, how would you accomplish this? I thought to create a
>> secondary address in R1 with an IP Classful Address Mask (10.0.0.1/8)
>> and complete the ARP Table for R3 physical interfaces with R2
>> Ethernet Mac Address (since R2 knows the complete network).- I Think
>> this could work Ok / Have not tested yet .. Can you see another was
>> of accomplishing this task?
>>
>>
>> Regards
>> Victor.
>>
>> _______________________________________________________________________
>> Subscription information may be found at:
>> http://www.groupstudy.com/list/CCIELab.html
>
>
> _______________________________________________________________________
> Subscription information may be found at:
> http://www.groupstudy.com/list/CCIELab.html
This archive was generated by hypermail 2.1.4 : Sun Nov 06 2005 - 22:00:50 GMT-3