RE: IPV6 quesiont

From: Lee Donald (Lee.Donald@t-systems.co.uk)
Date: Tue Oct 11 2005 - 05:47:01 GMT-3

• Next message: steven richards: "Configuring multicast on interface withought an ip address"
• Previous message: Stefan Grey: "IPV6 quesiont"
• Maybe in reply to: Stefan Grey: "IPV6 quesiont"
• Next in thread: Scott Morris: "RE: IPV6 quesiont"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

Stefan,

When you enable ipv6 on an interface it will use it's own link local address
unless you specify another one, and because this is an Ethernet connection,
icmp neighbour discovery can work ( instead of arp.

Rip will work over these addresses.

Regards

Lee.

-----Original Message-----
From: Stefan Grey [mailto:examplebrain@hotmail.com]
Sent: Tuesday, October 11, 2005 9:34 AM
To: ccielab@groupstudy.com
Subject: IPV6 quesiont

Hi,

   e0- R1 -e1- e1- R2-e0

1. What does the ipv6 enable command?

2. ipv6 addresses are configured on e0 interfaces of R1 and R2. ipv6 rip 1
enable is configured on all ethernet interfaces of R1 and R2. On e1 int of
R1 and R2 is configured ipv6 enable command. e0 interfaces are pingable from

each other. How was it possible to configure RIPv6 between routers without
having ipv6 addresses on e1 interfaces???

thanks.

• Next message: steven richards: "Configuring multicast on interface withought an ip address"
• Previous message: Stefan Grey: "IPV6 quesiont"
• Maybe in reply to: Stefan Grey: "IPV6 quesiont"
• Next in thread: Scott Morris: "RE: IPV6 quesiont"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

This archive was generated by hypermail 2.1.4 : Sun Nov 06 2005 - 22:00:50 GMT-3