The default value in port-security ?

From: Kevin (trung@vnsystem.net)
Date: Mon Oct 10 2005 - 04:46:08 GMT-3

• Next message: Shanky: "Re: The default value in port-security ?"
• Previous message: Stefan Grey: "BE in FRame-relay"
• Next in thread: Shanky: "Re: The default value in port-security ?"
• Maybe reply: Shanky: "Re: The default value in port-security ?"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

Hi Group,

In the CCNP 3: Multilayer Switching book (ISBN 1-58713-143-9) page 607, Wayner
Lewis stated that the switchport port-security maximum-number-of-addresses
command is used to set the maximum munber of secure MAC address for the
interface. The range is 1 to 128 and the default is 128 .

Well, i did show port-security on both cat2950 & 3550, and the default is
always 1.

So what's the point ? Is this a mistake from Cisco book or there's something
else that i didn't notice.

Thanks.

Kevin

• Next message: Shanky: "Re: The default value in port-security ?"
• Previous message: Stefan Grey: "BE in FRame-relay"
• Next in thread: Shanky: "Re: The default value in port-security ?"
• Maybe reply: Shanky: "Re: The default value in port-security ?"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

This archive was generated by hypermail 2.1.4 : Sun Nov 06 2005 - 22:00:50 GMT-3