Re: Switch line card information

From: James Ventre (messageboard@ventrefamily.com)
Date: Tue Oct 04 2005 - 09:39:54 GMT-3


 The defaults worked out well for our voice implementation - I'm using
queue #4 for voice payload.

James

Tx queue size ratio:
Queue # Sizes - percentage (* abs values)
------- -------------------------------------
1 65% (778368 bytes)
2 15% (187008 bytes)
3 15% (187008 bytes)
4 5% (68736 bytes)
Rx queue size ratio:
Rx queue size-ratio feature is not supported for this port type.
Tx WRR Configuration of ports with speed 1000Mbps:
Queue # Ratios (* abs values)
------- -------------------------------------
1 20 (20480 bytes)
2 100 (102400 bytes)
3 200 (204800 bytes)

James

Hoogen wrote:

  Thanks James. Have you got any queuing mechanisms enabled to
  prioritize voice traffic in the egress queue? TIAHoogen

  On 10/4/05, James Ventre <messageboard@ventrefamily.com> wrote:

    6509E> sh port capa 2
    Model WS-X6724-SFP
    Port 2/1
    Type 1000BaseSX
    Auto MDIX yes
    AuxiliaryVlan no
    Broadcast suppression percentage(0-100)
    Channel yes
    COPS port group 2/1-24
    CoS rewrite yes
    Dot1q-all-tagged yes
    Dot1x yes
    Duplex full
    Fast start yes
    Flow
    control receive-(off,on,desired),send-(off,on,desired)
    Inline power no
    Jumbo frames yes
    Link debounce timer yes
    Link debounce timer delay yes
    Membership static,dynamic
    Port ASIC group 2/1-12
    Port Security ACL yes
    Port VLAN Mapping Group: 2/1-12 Maximum Allowed
    Mappings: 128
    QOS scheduling rx-(1q8t),tx-(1p3q8t)
    Security yes
    SPAN source,destination
    Speed 1000
    Sync restart delay no
    ToS rewrite DSCP
    Trunk encap type 802.1Q,ISL
    Trunk mode on,off,desirable,auto,nonegotiate
    UDLD yes

    James

    Hoogen wrote:
> Hi All,
> Does any one have WS-6724-SFP module working on their 6500
    cisco switches.
> I need a *show interfaces capabilities* output of it to judge
    the egress
> queuing capabilities. Any suggestions regarding the queuing
    capabilities? I
> am gettting dscp packets on the trunk link and trusting them
    but somehow i
> believe i have to change them into COS packets before applying
    any queuing
> mechanisms like wrr or wred.
> TIA
> Hoogen
>
>
    _______________________________________________________________________
> Subscription information may be found at:
> http://www.groupstudy.com/list/CCIELab.html



This archive was generated by hypermail 2.1.4 : Sun Nov 06 2005 - 22:00:49 GMT-3