From: Brian McGahan (bmcgahan@internetworkexpert.com)
Date: Wed Sep 28 2005 - 17:18:29 GMT-3
Stefan,
Assuming you are referring to Frame Relay QoS it depends if you
are doing per-VC queueing or not. By default there is one shared output
queue for the interface regardless of how many VCs or subinterfaces you
have. In this case QoS is applied to the main interface since there is
only one output queue, and hence only one "bandwidth" value that is
significant.
With legacy and MQC based Frame Relay Traffic Shaping each VC is
assigned a separate output queue that in turn contends for the transmit
ring of the interface. Since there are separate output queues you can
apply separate QoS attributes onto then, either at the main interface,
subinterface, or VC level. In this case the available bandwidth for a
particular queue is based on the "mincir" value, either as defined by
the "frame-relay mincir" command in legacy FRTS or the "shape adaptive"
command in the MQC. By default this value is half of the configured
"cir" or "average" rate.
If you have a specific practice lab task that you want more
information about for QoS feel free to post it, otherwise check here for
more information:
http://www.cisco.com/en/US/tech/tk543/tk544/technologies_tech_note09186a
00800a4754.shtml
HTH,
Brian McGahan, CCIE #8593
bmcgahan@internetworkexpert.com
Internetwork Expert, Inc.
http://www.InternetworkExpert.com
Toll Free: 877-224-8987 x 705
Outside US: 775-826-4344 x 705
24/7 Support: http://forum.internetworkexpert.com
Live Chat: http://www.internetworkexpert.com/chat/
> -----Original Message-----
> From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On Behalf
Of
> Stefan Grey
> Sent: Wednesday, September 28, 2005 11:25 AM
> To: ccielab@groupstudy.com
> Subject: MQC bandwidth
>
> Hello group,
>
> Question:
>
> "Output queue calculations for the MQC are based on the configured
> bandwidth
> value of the interface and not the speed the interface is clocked at.
Be
> sure to set the appropriate bandwidth value when configuring the MQC
on an
> interface."
>
> When we configure CBWFQ on the subinterface should we configure the
> reference bandwidth on the subinterface itself or on the physical
> interface.
> Where does router look for reference??
>
> _________________________________________________________________
> Browse smarter with tabs - get the all-new MSN Toolbar!
> http://toolbar.msn.ie
>
>
This archive was generated by hypermail 2.1.4 : Sun Oct 02 2005 - 14:40:17 GMT-3