From: simon hart (simon@harttel.com)
Date: Wed Sep 28 2005 - 15:08:31 GMT-3
Stefan,
What type of subinterface?
For example if it is a frame relay subinterface you will need to configure
frame relay traffic shaping in order to assign CBWFQ. By doing so you will
either set CIR or min CIR within a Map-class Frame-relay.
In such a case then the MQC will take half of the configured CIR or the
configured minCIR.
CBWFQ is not supported on Ethernet subinterfaces
Router output----------
Router(config)#int fa1/0.1
Router(config-subif)#service-policy out QOS
CBWFQ : Not supported on subinterfaces
Simon
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com]On Behalf Of
Stefan Grey
Sent: 28 September 2005 17:25
To: ccielab@groupstudy.com
Subject: MQC bandwidth
Hello group,
Question:
"Output queue calculations for the MQC are based on the configured bandwidth
value of the interface and not the speed the interface is clocked at. Be
sure to set the appropriate bandwidth value when configuring the MQC on an
interface."
When we configure CBWFQ on the subinterface should we configure the
reference bandwidth on the subinterface itself or on the physical interface.
Where does router look for reference??
This archive was generated by hypermail 2.1.4 : Sun Oct 02 2005 - 14:40:16 GMT-3