From: Tim (ccie2be@nyc.rr.com)
Date: Sat Sep 17 2005 - 23:01:25 GMT-3
Jeff,
By default, flow control isn't an issue when it comes to QoS. However, in
the lab, you should ALWAYS double check to see whether non-default settings
have been pre-configured.
Remember part of the challenge of passing the lab is being able to
troubleshoot problems while under time pressure. So, don't assume any
setting is at its default.
HTH, Tim
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On Behalf Of
Ryan, Jeff
Sent: Saturday, September 17, 2005 9:42 PM
To: ccielab@groupstudy.com
Subject: mls QoS question
All, when enabling QoS on the 3550, I always get the following:
Rack1SW2(config)#mls qos
QoS: ensure flow-control on all interfaces are OFF for proper operation.
Does anyone go under the interfaces in question and disable flow control
as standard?
Thanks,
Jeff
This archive was generated by hypermail 2.1.4 : Sun Oct 02 2005 - 14:40:15 GMT-3