From: Edwards, Andrew M (andrew.m.edwards@boeing.com)
Date: Thu Sep 15 2005 - 17:49:05 GMT-3
How can R2 pass the RPF if there is no route in its IGP from R4 towards
R4's Lo0?
Look at R4 IGP and R2's RPF check towards R4 as the RP for the specified
groups.
HTH,
andy
-----Original Message-----
From: Schulz, Dave [mailto:DSchulz@dpsciences.com]
Sent: Thursday, September 15, 2005 1:14 PM
To: ccielab@groupstudy.com
Subject: Multicast issue: Auto-RP over Sparse-Dense mode
Here is the situation.... I am doing multicast with Auto-RP over
Sparse-Dense (configs below). R2 has a DLCI to R3 and R4 (multipoint
subif), and, also a point-to-point subinterface on a separate dlci to
R5.
R2 is announcing itself as the RP for groups 224.2.2.0
R4 is announcing itself as the RP for groups 224.4.4.0
I believe the configurations are correct. However, when I do the show
ip pim rp map, I get the following:
R2#sh ip pim rp map
PIM Group-to-RP Mappings
This system is an RP (Auto-RP)
This system is an RP-mapping agent (Serial0.2)
Group(s) 224.2.2.0/24
RP 20.20.20.1 (?), v2v1
Info source: 20.20.20.1 (?), via Auto-RP
Uptime: 23:19:40, expires: 00:02:15
R3#sh ip pim rp map
PIM Group-to-RP Mappings
Group(s) 224.2.2.0/24
RP 20.20.20.1 (?), v2v1
Info source: 172.16.1.2 (?), via Auto-RP
Uptime: 23:18:23, expires: 00:02:39
R3#
R4# sh ip pim rp map
PIM Group-to-RP Mappings
This system is an RP (Auto-RP)
Group(s) 224.2.2.0/24
RP 20.20.20.1 (?), v2v1
Info source: 172.16.1.2 (?), via Auto-RP
Uptime: 00:00:05, expires: 00:02:50
Group(s) 224.4.4.0/24
RP 40.40.40.1 (?), v2v1
Info source: 40.40.40.1 (?), via Auto-RP
Uptime: 23:06:44, expires: 00:01:17
R5#sh ip pim rp map
PIM Group-to-RP Mappings
Group(s) 224.2.2.0/24
RP 20.20.20.1 (?), v2v1
Info source: 172.16.1.2 (?), via Auto-RP
Uptime: 23:05:19, expires: 00:02:50
Problem: for some reason, I cannot get the 224.4.40 group to be mapped
throughout the network. I run the same scenario under BSR and it works
fine. Also, running the MRM utility shows no errors. Thoughts? Here
are the configs......
hostname R2
ip multicast-routing
!
interface Loopback0
ip address 20.20.20.1 255.255.255.0
ip pim sparse-dense-mode
!
interface Serial0
no ip address
encapsulation frame-relay
no frame-relay inverse-arp
frame-relay lmi-type cisco
!
interface Serial0.1 multipoint
ip address 192.168.1.2 255.255.255.0
ip pim nbma-mode
ip pim sparse-mode
frame-relay map ip 192.168.1.2 203
frame-relay map ip 192.168.1.3 203 broadcast
frame-relay map ip 192.168.1.4 204 broadcast
no frame-relay inverse-arp
!
interface Serial0.2 point-to-point
ip address 172.16.1.2 255.255.255.0
ip pim sparse-dense-mode
ip igmp join-group 224.4.4.4
frame-relay interface-dlci 205
!
router eigrp 1
network 172.16.0.0
network 192.168.1.0
no auto-summary
no eigrp log-neighbor-changes
!
ip pim send-rp-announce Loopback0 scope 16 group-list 1
ip pim send-rp-discovery Serial0.2 scope 16
!
ip mrm manager TST
manager Loopback0 group 224.4.4.4
senders 8
receivers 9 sender-list 8
!
access-list 1 permit 224.2.2.0 0.0.0.255
access-list 8 permit 50.50.50.1
access-list 9 permit 40.40.40.1
!
R3
hostname R3
ip multicast-routing
!
interface Loopback0
ip address 30.30.30.1 255.255.255.0
ip pim sparse-dense-mode
!
interface Serial0
ip address 192.168.1.3 255.255.255.0
ip pim sparse-dense-mode
encapsulation frame-relay
frame-relay map ip 192.168.1.2 302 broadcast
frame-relay map ip 192.168.1.3 302
frame-relay map ip 192.168.1.4 302 broadcast
no frame-relay inverse-arp
frame-relay lmi-type cisco
!
router eigrp 1
network 192.168.1.0
no auto-summary
no eigrp log-neighbor-changes
!
R4
hostname R4
ip multicast-routing
!
interface Loopback0
ip address 40.40.40.1 255.255.255.0
ip pim sparse-dense-mode
ip mrm test-receiver
!
interface Serial0
ip address 192.168.1.4 255.255.255.0
ip pim sparse-dense-mode
encapsulation frame-relay
frame-relay map ip 192.168.1.2 402 broadcast
frame-relay map ip 192.168.1.3 402 broadcast
frame-relay map ip 192.168.1.4 402
no frame-relay inverse-arp
frame-relay lmi-type cisco
!
router eigrp 1
network 192.168.1.0
no auto-summary
no eigrp log-neighbor-changes
!
ip pim send-rp-announce Loopback0 scope 16 group-list 1
!
access-list 1 permit 224.4.4.0 0.0.0.255
!
R5
hostname R5
ip multicast-routing
!
interface Loopback0
ip address 50.50.50.1 255.255.255.0
ip pim sparse-dense-mode
ip mrm test-sender
!
interface Serial0
ip address 172.16.1.5 255.255.255.0
ip pim sparse-dense-mode
encapsulation frame-relay
frame-relay interface-dlci 502
frame-relay lmi-type cisco
!
router eigrp 1
network 172.16.0.0
no auto-summary
no eigrp log-neighbor-changes
!
end
Dave Schulz
Email: dschulz@dpsciences.com <mailto:dschulz@dpsciences.com >
This archive was generated by hypermail 2.1.4 : Sun Oct 02 2005 - 14:40:15 GMT-3