From: Ahmed Ossama (ahmed_ossama@rayatelecom.net)
Date: Sun Sep 11 2005 - 08:02:32 GMT-3
Dear All,
I have something that confuses me a lot, if we have a serial interface
with T1 speed, as far as I know if we put service policy under it and
the total bandwidth commands under the service policy exceed 75% an
error message will be generated.
But what I am asking about it that when I do it under the frame relay
pvc nothing is happened.
What I do is configure 2 frame relay PVCs each with CIR 1024 and min cir
1024 and I configure under each class a policy map take 75% of the
bandwidth, which mean that the total bandwidth take is about 150% of the
interface and the router accept the command and this confuses me a lot.
Here is the configuration I made
policy-map 2
class class-default
bandwidth percent 75
!
interface Serial1/0
ip address 144.1.15.5 255.255.255.0
ip pim sparse-mode
encapsulation frame-relay
no fair-queue
serial restart-delay 0
frame-relay traffic-shaping
frame-relay interface-dlci 501
class 1
frame-relay interface-dlci 502
class 2
frame-relay lmi-type cisco
!
map-class frame-relay 1
frame-relay cir 1024000
frame-relay mincir 1024000
no frame-relay adaptive-shaping
service-policy output 1
!
map-class frame-relay 2
frame-relay cir 1024000
frame-relay mincir 1024000
no frame-relay adaptive-shaping
service-policy output 2
what I am asking is what is the behaviour of the router under such
configuration
thanks a lot
This archive was generated by hypermail 2.1.4 : Sun Oct 02 2005 - 14:40:14 GMT-3