From: Mike Flanagan (mikenoc@mindspring.com)
Date: Wed Sep 07 2005 - 05:30:36 GMT-3
Hello,
I am trying to configure Port Security to only allow one Mac address.
When doing a show run on the interface it is not showing the command
switchport port-security maximum 1. But when I do a show port sec on
the interface it says maximum Mac addresses configured it shows only
one. So even though it is not showing the maximum 1 command on the
interface it should be working properly correct ?
Thanks,
Mike F.
SW1(config-if)#do sh port-sec int gig1/0/8
Port Security : Enabled
Port Status : Secure-down
Violation Mode : Shutdown
Aging Time : 0 mins
Aging Type : Absolute
SecureStatic Address Aging : Disabled
Maximum MAC Addresses : 1
Total MAC Addresses : 1
Configured MAC Addresses : 1
Sticky MAC Addresses : 0
Last Source Address : 0000.0000.0000
Security Violation Count : 0
SW1(config-if)#
This archive was generated by hypermail 2.1.4 : Sun Oct 02 2005 - 14:40:14 GMT-3