From: kumara.shunmugam@wipro.com
Date: Tue Sep 06 2005 - 08:11:19 GMT-3
Hi
Can any one comment on the above two command support on Cat3550. Many forums
say that the 3550 will not properly support bandwidth command under policy-map
(egress queue). If we want to change the bandwidth, the only way is to go is
by using "wrr-queue bandwidth command. But I think the wrr-queue bandwidth
command is the mechanism to assign weights to each queue. Where as the
policy-map will provide minimum bandwidth guarantee for an identified traffic
during time of congestion. Can anyone discuss the policy-map limitations in
3550?
Regards
Shun
Confidentiality Notice
The information contained in this electronic message and any attachments to
this message are intended
for the exclusive use of the addressee(s) and may contain confidential or
privileged information. If
you are not the intended recipient, please notify the sender at Wipro or
Mailadmin@wipro.com immediately
and destroy all copies of this message and any attachments.
This archive was generated by hypermail 2.1.4 : Sun Oct 02 2005 - 14:40:14 GMT-3