From: mushtaq A. Khan (mak.ccie2b@gmail.com)
Date: Fri Sep 02 2005 - 09:43:56 GMT-3
Not only "Bob" and "NEW" worked, "Ghost" also worked fine :-D.
Thanks a lot.
Mushtaq
On 9/2/05, Scott Morris <swm@emanon.com> wrote:
>
> You could also "redistribute connected route-map Bob" and specify which
> ones
> you want to bring in. :)
>
> -----Original Message-----
> From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On Behalf Of
> mushtaq A. Khan
> Sent: Friday, September 02, 2005 6:42 AM
> To: McCallum, Robert
> Cc: Cisco certification
> Subject: Re: How to assign Loopback to IS-IS
>
> Robert,
> Yeah, it works but it also redistribute all other connected interface
> which
> are not required to be advertised.
> Passive interface commands work well to announce any specific interface
> but
> it is kind of contradicting with other routing protocol where it is used
> to
> block routing updates.
> Mushtaq
>
> On 9/2/05, McCallum, Robert <robert.mccallum@thus.net> wrote:
> >
> > Redistribute connected
> >
> > -----Original Message-----
> > From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On Behalf
> > Of mushtaq A. Khan
> > Sent: 02 September 2005 09:33
> > To: Cisco certification
> > Subject: How to assign Loopback to IS-IS
> >
> > Can someone tell me how to assign loopback to is-is without using "IP
> > router isis" command.
> > Thanks,
> > Mushtaq
> >
> > ______________________________________________________________________
> > _ Subscription information may be found at:
> > http://www.groupstudy.com/list/CCIELab.html
>
> _______________________________________________________________________
> Subscription information may be found at:
> http://www.groupstudy.com/list/CCIELab.html
This archive was generated by hypermail 2.1.4 : Sun Oct 02 2005 - 14:40:13 GMT-3