From: Scott Morris (swm@emanon.com)
Date: Fri Sep 02 2005 - 09:13:34 GMT-3
You could also "redistribute connected route-map Bob" and specify which ones
you want to bring in. :)
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On Behalf Of
mushtaq A. Khan
Sent: Friday, September 02, 2005 6:42 AM
To: McCallum, Robert
Cc: Cisco certification
Subject: Re: How to assign Loopback to IS-IS
Robert,
Yeah, it works but it also redistribute all other connected interface which
are not required to be advertised.
Passive interface commands work well to announce any specific interface but
it is kind of contradicting with other routing protocol where it is used to
block routing updates.
Mushtaq
On 9/2/05, McCallum, Robert <robert.mccallum@thus.net> wrote:
>
> Redistribute connected
>
> -----Original Message-----
> From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On Behalf
> Of mushtaq A. Khan
> Sent: 02 September 2005 09:33
> To: Cisco certification
> Subject: How to assign Loopback to IS-IS
>
> Can someone tell me how to assign loopback to is-is without using "IP
> router isis" command.
> Thanks,
> Mushtaq
>
> ______________________________________________________________________
> _ Subscription information may be found at:
> http://www.groupstudy.com/list/CCIELab.html
This archive was generated by hypermail 2.1.4 : Sun Oct 02 2005 - 14:40:13 GMT-3