From: Mark Forest (mforest@inetiq.com)
Date: Sun Aug 28 2005 - 23:19:34 GMT-3
It depends on the situation..
If it is a single port that is sharing a trunk link with the switch then you
need to look at multiple vlans and configure subinterfaces on the router
side with the correct encapsulation and then assign each sub interface to
the vlans.
If there are multiple vlans on the interface and you can only have one ip
address then you need to look at bvi interfaces..
I will not give the answer as that does not teach anything.. So look at each
situation and the answer should become clear.
mf
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On Behalf Of
Schulz, Dave
Sent: Sunday, August 28, 2005 9:58 PM
To: ccielab@groupstudy.com
Subject: IPExpert Lab N - Vlan configurations
I am working with an IPexpert lab N, it is required to have single router
port in two Vlans. Since a router port is connected to a single switch
port....how is it possible to assign multiple vlans to a single switchport?
This appears to be maybe an error in the documentation, or, am I missing
something? I know that I can assign a secondary address to the router, but
the switchport with multiple vlans is a gottcha. Hmmmm....any ideas?
Dave
This archive was generated by hypermail 2.1.4 : Sun Sep 04 2005 - 17:01:20 GMT-3