From: Brian Dennis (bdennis@internetworkexpert.com)
Date: Wed Aug 17 2005 - 00:05:11 GMT-3
If the remote side is DCE make sure that the clock rate is 128000 or
less.
HTH,
Brian Dennis, CCIE #2210 (R&S/ISP-Dial/Security)
bdennis@internetworkexpert.com
Internetwork Expert, Inc.
http://www.InternetworkExpert.com
Toll Free: 877-224-8987
Direct: 775-745-6404 (Outside the US and Canada)
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On Behalf Of
Thomas
Sent: Tuesday, August 16, 2005 7:20 PM
To: ccielab@groupstudy.com
Subject: Connect to NM-4A/S
Hi,
I have a NM-4A/S module installed in 2600 router. But I can't make the
interface up/up. No matter what encapsulation type,hdlc, ppp, with or
without
clock rate, the serial interface is up/down. I can see the interface is
in
sync mode.
Could someone help to give an example on how to configure it to connect
to
just a 2500 router?
Thank you very much.
Regards,
Thomas
This archive was generated by hypermail 2.1.4 : Sun Sep 04 2005 - 17:01:19 GMT-3