From: Vazman (vazman@gmail.com)
Date: Tue Aug 16 2005 - 23:58:43 GMT-3
1. Post the show run, sh interface, sh version and show diag
2. Check the cable for any pins that are bend. Try another cable.
There is nothing special configuration wise for a NM-4A/S.
HTH
On 8/16/05, Thomas <thomascheung2003@hotmail.com> wrote:
> Hi,
>
> I have a NM-4A/S module installed in 2600 router. But I can't make the
> interface up/up. No matter what encapsulation type,hdlc, ppp, with or without
> clock rate, the serial interface is up/down. I can see the interface is in
> sync mode.
> Could someone help to give an example on how to configure it to connect to
> just a 2500 router?
> Thank you very much.
>
> Regards,
>
> Thomas
>
> _______________________________________________________________________
> Subscription information may be found at:
> http://www.groupstudy.com/list/CCIELab.html
This archive was generated by hypermail 2.1.4 : Sun Sep 04 2005 - 17:01:19 GMT-3