From: Arun Arumuganainar (aarumuga@hotmail.com)
Date: Sat Aug 13 2005 - 01:49:00 GMT-3
Hmmm ... I am not an Expert on ISDN . But this is what my understanding !!!
There are two ways of configuring Bandwidth aggrigation 1) PPP Multilink
and 2) BOD . Functionality wise both are exactly the same .
Two Channels to same destination
1 Route in the routing table .
But the difference between them is that PPP multilink is standard fromat
while BOD is cisco properitary !!!
Note : BOD is used when both the ends are CISCO !!! If you are dialing in to
non cisco devices PPP multilink is the only option
Thanks and Regards
Arun
----- Original Message -----
From: <gladston@br.ibm.com>
To: <ccielab@groupstudy.com>
Sent: Friday, August 12, 2005 11:46 PM
Subject: Re: Re: config - ISDN B-Channel 2 links - up ---> Doubt
> Arun,
>
> Would you agree with Shanky?
>
> I am not sure if you stating a different point.
>
> Configuring 'dialer load-threshold..' without 'ppp multilink':
> -- two channels to the same destination
> -- two entries on the routing table
>
> On the other hand, configuring 'dialer load-threshold..' with 'ppp
multilink':
>
> -- two channels to the same destination
> -- one entry on the routing table
>
> Could you think about an example when 'dialer load-threshold' without ppp
multilink would be used?
>
> _______________________________________________________________________
> Subscription information may be found at:
> http://www.groupstudy.com/list/CCIELab.html
This archive was generated by hypermail 2.1.4 : Sun Sep 04 2005 - 17:01:19 GMT-3