From: gladston@br.ibm.com
Date: Sun Aug 07 2005 - 21:11:55 GMT-3
Hi,
Did you check packets generated when using informs?
I could see then when using Traps, but no luck with Informs:
Config:
snmp-server enable informs
snmp-server host 148.5.2.1 informs version 2c Commu-inform config
Testing using 'access-list 140 permit udp an an eq 162' and "debug ip nbar capture.." does not show any packets.
If testing Traps, those commands indicates the packets going on:
snmp-server enable traps
snmp-server host 148.5.2.1 Community
*Mar 3 04:33:19: %SEC-6-IPACCESSLOGP: list 140 permitted udp 148.5.11.1(51070) (ATM2/0.1211 ) -> 148.5.2.1(162), 3 packets
148.5.201.11:51070 <--> 148.5.2.1:162(udp)
FF[1 ] UDP 148.5.201.11(51070) -> 148.5.2.1(162 )
45 00 00 8c 00 04 00 00 fe 11 c9 45 94 05 c9 0b E..........E....
94 05 02 01 c7 7e 00 a2 00 78 da 53 30 6e 02 01 .........x.S0n..
00 04 09 43 6f 6d 6d 75 6e 69 74 79 a4 5e 06 09 ...Community.^..
2b 06 01 04 01 09 09 2b 02 40 04 94 05 c9 0b 02 +......+.@......
01 06 02 01 01 43 04 01 1d c5 9f 30 3f 30 13 06 .....C.....0?0..
0e 2b 06 01 04 01 09 09 2b 01 01 06 01 03 18 02 .+......+.......
01 01 30 13 06 0e 2b 06 01 04 01 09 09 2b 01 01 ..0...+......+..
06 01 04 18 02 01 03 30 13 06 0e 2b 06 01 04 01 .......0...+....
09 09 2b 01 01 06 01 05 18 02 01 02 ..+.........
FF[2 ] UDP 148.5.201.11(51070) -> 148.5.2.1(162 )
Thanks for any feedback.
This archive was generated by hypermail 2.1.4 : Sun Sep 04 2005 - 17:01:18 GMT-3