From: Schulz, Dave (DSchulz@dpsciences.com)
Date: Tue Jul 12 2005 - 08:42:46 GMT-3
Amit -
I am going to take a shot at this one. In OSPF, the databases at all routes
that have adjancies...must have the same database. Therefore, I would think
that filtering (through a distribute list) this information would break the
OSPF rules. However, if you do this inbound....you are filtering the
information from the OSPF database that exists as it is presented into the
route table. Does this sound accurate?
Dave
-----Original Message-----
From: nobody@groupstudy.com
To: Group Study
Sent: 7/12/2005 6:33 AM
Subject: Distribute-list in OSPF
Hi Group
When I am applying a distribute-list in OSPF its giving an error :
Rack4R1(config-router)#distribute-list 50 out s0/0
% Interface not allowed with OUT for OSPF
Or
Rack4R1(config-router)#distribute-list prefix R2 out s0/0
% Interface not allowed with OUT in case of OSPF
My s0/0 is a frame relay physcal interface with ip ospf network type
point-to-multipoint non-broadcast defined. Inverse arp is disabled on
interface.
IOS on the router is 12.2(15)T7
Has anybody seen this problem before?
Thanks
Amit jain
This archive was generated by hypermail 2.1.4 : Sun Sep 04 2005 - 17:00:29 GMT-3