From: Chris Lewis \(chrlewis\) (chrlewis@cisco.com)
Date: Thu Jul 07 2005 - 11:54:00 GMT-3
Depends what encapsulation type you are using for DLSw :)
Assuming you're talking about FST, which is the only tricky one IMHO,
something like the following will identify it in an ACL
Access-list 100 permit 91 any any
Protocol 91 is Locus Address Resolution Protocol. The only way to
confirm this I know of is to setup FST encapsulation between two
routers, turn on debug ip packet detail and look at the log, then you'll
see the protocol 91 and if interested look up on IANA what protocol 91
is at http://www.iana.org/assignments/protocol-numbers
Chris
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On Behalf Of
Amit Jain
Sent: Thursday, July 07, 2005 6:42 AM
To: Group Study
Subject: protocol type-code information on DocCD
Hi
In the DLSW examples where we have to permit/deny traffic based on
protocol type-code, I am have difficulty figuring out the correct
type-code. Can somebody help me locate the same on DocCd ?
Amit
This archive was generated by hypermail 2.1.4 : Sun Sep 04 2005 - 17:00:29 GMT-3