From: Nawaz, Ajaz (Ajaz.Nawaz@bskyb.com)
Date: Tue Jun 28 2005 - 12:10:00 GMT-3
cmd - ip address negotiated
ajaz
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On Behalf Of
ccie2be
Sent: 28 June 2005 14:47
To: Group Study
Subject: Dialer Profiles
Hi guys,
Are there any ways to configure multiple dialer interfaces without assigning
an ip subnet to each dialer interface?
I'm trying to figure out how to fulfill the following requirements:
1. allowed the circuit to come up only if the primary path is down - don't
allow any traffic including pings to bring up the circuit if the primary is
up.
2. Allow pings to bring up the circuit for testing purposes.
3. Do not add any ip addresses
If someone has an example of how this could be configured, I'd be very
grateful.
TIA, Tim
This archive was generated by hypermail 2.1.4 : Wed Jul 06 2005 - 14:43:45 GMT-3