From: John Matus (john_matus@hotmail.com)
Date: Fri Jun 24 2005 - 17:02:19 GMT-3
i'm having trouble w/ my ipv6 isis adj
here is my debug.
i'm not sure of the cmmand to use for isis ipv6 adj info: is it still "sh
clns nei" or "show isis top"?
*Mar 1 01:09:31.087: ISIS-Adj: Sending L2 LAN IIH on Serial0/0.124, length
1500
*Mar 1 01:09:31.307: ISIS-Adj: Rec L2 IIH from DLCI 401 (Serial0/0.124),
cir type L1L2, cir id 0001.0001.0004.01, length 1500
*Mar 1 01:09:31.311: ISIS-Adj: L1 adj count 0
*Mar 1 01:09:31.311: ISIS-Adj: New adjacency, level 1 & 2 for DLCI 401
*Mar 1 01:09:32.087: ISIS-Adj: Sending L2 LAN IIH on Serial0/0.124, length
1500
r4(config-subif)#
*Mar 1 01:09:32.115: ISIS-Adj: Sending L1 LAN IIH on Serial0/0.124, length
1500
*Mar 1 01:09:32.311: ISIS-Adj: Rec L2 IIH from DLCI 401 (Serial0/0.124),
cir type L1L2, cir id 0001.0001.0004.01, length 1500
*Mar 1 01:09:32.311: ISIS-Adj: L1 adj count 1
*Mar 1 01:09:32.311: ISIS-Adj: L2 adj count 1
*Mar 1 01:09:32.311: ISIS-Adj: Adjacency state goes to Up
*Mar 1 01:09:32.311: ISIS-Adj: Run level-1 DR election for Serial0/0.124
*Mar 1 01:09:32.311: ISIS-Adj: No change (it's us)
*Mar 1 01:09:32.315: ISIS-Adj: Run level-2 DR election for Serial0/0.124
*Mar 1 01:09:32.315: ISIS-Adj: New level-2 DR 0001.0001.0004 on Serial0/0.1
This archive was generated by hypermail 2.1.4 : Wed Jul 06 2005 - 14:43:43 GMT-3