From: ccie2be (ccie2be@nyc.rr.com)
Date: Thu Jun 23 2005 - 21:45:18 GMT-3
-If the busy-message command is used without the service hide-telnet-address
command, only the busy message is displayed. If both commands are used, the
address is suppressed but other messages aren't.
-To have the host refusing a connection (all lines are in-use) send a custom
message, use the refuse-message <string> command. Use this command under the
line vty 0 4 mode.
-When a telnet session is started from a router, by default, certain info
such as ip addr, hostname, etc is displayed. There are several commands
that begin with ip telnet that can alter what's displayed. Use ip telnet ?
to see the 4 options available.
I'm fairly sure that the busy-message is configured on the router from which
the telnet session originates. While the refuse message is configured on the
router that is receiving the telnet connection.
HTH, Tim
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On Behalf Of John
Matus
Sent: Thursday, June 23, 2005 7:05 PM
To: ccielab@groupstudy.com
Subject: busy msg vs. refuse msg
ok, i think these are correct but they "seem" like they should be the
oposite
line in use message = refuse message
no connection available = busy message.........
???
This archive was generated by hypermail 2.1.4 : Wed Jul 06 2005 - 14:43:43 GMT-3